Electrical Safety - ACM RX2 Guia De Inicio Rapido

To memorise the remote controls, press the PROG key (see Fig.4) once to select channel 1 or twice to
select channel 2. The LED corresponding to the channel entering the learning mode will begin to flash;
press the button to be memorised on the remote control.
When memorisation is complete, the LED remains permanently on. Repeat the procedure to memori-
se other remote controls.
To delete all memorised codes from the radio receiver, press and hold the PROG key for a few seconds;
both the CN1 and CN2 LEDs will flash for a few seconds and then switch off, indicating that the de-
letion procedure has been completed.
If an attempt is made to memorise more than 146 codes, both LEDs will flash twice to indicate that
this is in fact impossible.
The manufacturer hereby declares that the "RX2" conforms to European Directive 99/05 and that the
standards listed in the following table have been applied:

ELECTRICAL SAFETY

EN 60335 I
ELECTROMAGNETIC
COMPATIBILITY
EN 301 489-1/3
EFFICIENT USE OF THE
SPECTRUM
EN 300 220-1/3
9