Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Instructions top case rack for mastech pannier
Note :
Do not �ghten the screws un�l they are completely aligned with the holes.
Before the installa�on, please verify through the manual that all pieces and parts are
complete.
Tools Required:
Hex Allen Wrench Set
Combination Wrench Set
Assembled Kit
Installa�on Kit
Side racks
Rear Sheet
pannier supports
pannier supports
1
2
QTTY:
1
QTTY:
1
special
aluminum spacer
aluminum spacer
H 10mm
4
3
Can�dad:
4
8
Can�dad:
socket M8x20
socket M8x20
Was M8
6
7
Can�dad:
4
Can�dad:
2
After the installation of the parts, please check that they are aligned and that all the hardware is properly tightened
Calle 76 # 52D - 74 / Telefax: (57+4) 448 8428 / Medellín - Colombia
special
ocket M8x20
aluminum spacer
Was M8
aluminum spacer
H 5mm
5
Can�dad:
4
socket M6x50
Was M6
8
8
Can�dad:
www.mastechno.com
V-STROM 650 AT/XT 17-UP
Installa�on
1.
On the rear plastics of the motorcycle, install de
accessories.
2.
Use for the Point (A) Hardware Kit 3,4,8
3.
Use for the Point (B) Hardware Kit 6
4.
Use the Hardware Kit 8 for the Point (C), if you do not
have the upper rack mount installed, use the Hard-
ware Kit 3,5,8
5.
Use the Hardware Kit 6 for the Point (D)
A
B
C
D
Publicidad
