Factory Default; Usals Setup - Qviart mini Manual Del Usuario

DiSEqC 1.2: General motor antenna using DiSEqC 1.2.
USALS: Motor antenna using USALS.
 Move Auto [W/E]
Press / button, the dish will be motorized to East/West continuously; it will stop until it
find the best signal
 Move west-east
Press / button, the dish will be motorized to East/West step by step, until you find the
best signal showed on the signal bar.
 Fine Tuning (1)
Input digital button to set the moving step
 Store Position
Save the current position you searched.
 Go to Position
Press OK button to move the dish to the position that you saved.
 Go to Reference
Press OK button to move the dish to 0 positions.
 Set West Limit
You can set the maximum motor limit for both West to prevent damage to the antenna.
 Set East Limit
You can set the maximum motor limit for both East to prevent damage to the antenna.
 Disable Limit
Disable West limit and East limit.
 Go to X.X
Press OK button to move the dish to the USALS Setup.
Tip: Before you use USALS, you should go to Main Menu ->INTALLATION -> USALS Setup to set
you local position firstly.

3.2 Factory Default

1. Menu->INSTALLTION -> Factory Default
2. Highlight the option you want and press the OK button to execute it.

3.3 USALS Setup

Menu-> INSTALLTION ->USALS Setup
If you set the Motor Mode to USALS, you need set the longitude and the latitude in USALS
Setup.
Setup By Country: Press the RED button, you can choose the country, press OK button.
4. Edit Channel
7