Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMING OF THE SELECTOR THROUGH RADIO
- 5 -
code ACG9446
CAUTION: BEFORE CLOSING THE COVER, TIGHTEN LOCK SCREWS - 7 -.
- 7 -
- 1 -
- 3 -
CAUTION: CUT OFF POWER SUPPLY BEFORE INSERTING THE CARD
- 4 -
- Connect the batteries - 1 - code SLI0012 to the connector in the rotary selector
- 2 -.
- Remove cover - 3 - from the control unit.
- Insert the card - 4 - code ACG9446 into one of the available slots.
- Press and hold down button - 5 - turning knob - 6 - of the selector to any position
until hearing a "BEEP" indicating that memorisation has been completed.
- Release key - 5 -.
- Close the control unit cover - 3 -.
- Select the desired function.
WARNING: when the selector is rotated, the receiver emits a long beep to
signal the change of state that has taken place.
Low battery => when the battery is low, the buzzer on the receiver emits 2 beeps
every 2 seconds thus signalling that the battery needs to be
replaced.
TECHNICAL SPECIFICATIONS FOR THE TRANSMITTER
code ACG9428 - ACG9430
- Power supply
- Transmission frequency
- Output power
- Band channelling
- Range
- Operating temperature
- Degree of protection
TECHNICAL SPECIFICATIONS FOR THE RECEIVER
code ACG9446
- Power supply
- Receiving frequency
- Input signal sensitivity
- Electrical input
- Connection
- Band channelling
- Operating temperature
7
- 2 -
- 6 -
code ACG9428
code ACG9430
code SLI0012
3V (Battery type AAA 1,5V X 2)
433,920 Mhz. +/- 0,2%
Max. 1mW
250 Khz
approximately 10 m
0°C ÷ +55°C
IP54
20 ÷ 28 Vdc
433,920 Mhz. +/- 0,2%
Max 10 dBuV
10 mA
Plug-in
250Khz
-20°C ÷ +55°C
G
B
Publicidad
