Installation Instructions - jablotron BM-02 Manual De Instrucciones

Warning:
The Nanny does not prevent the occurrence of sleep apnea in an infant! If operated and used in accordance
with this manual, the monitor is unlikely to fail.
1. Place the sensor pad into the crib (pram, Moses bas-
ket, etc.) under the mattress (or cushion) underne-
ath the area where the baby will be sleeping – see
the fi gure.
The center of the sensor pad should be approxima-
tely where the baby's chest is.
The pad should be placed on an even fi rm surface
with the printed side facing up – It must not be
bent!
If there is only a bed frame in the crib, place a fi rm
board under the sensor pad; e. g. hardboard, ply-
wood, etc. The base board should not cover the
whole crib surface so as not to prevent air circulati-
on – its satisfactory size overhangs the sensor pad by approx. 3 cm on each side.
For further installation advice and instructions read page 18, Frequently Asked Questions.
Note:
When using the BM-02 Nanny for twins it is absolutely necessary that each baby has its own crib provided
with an independent baby monitor. To ensure correct signal evaluation the cribs must not touch each other.
2. Insert batteries into the device (the battery compartment cover is on the back of the device).
To remove the battery compartment cover, push its straight edge gently and move it towards the round
edge – see Fig A.
Use only new alkaline batteries – AA type (do not use rechargeable batteries).
The polarity of batteries is clearly marked in the battery compartment.
Seal the battery compartment cover and turn the switch to position I.
If the batteries are in good condition, all 3 indicators will fl ash one after another and you will hear
a beep.
If there is no beep after turning the unit ON, check the batteries.
Wait approx. 3 seconds before turning the unit
on again – after turning the unit on its electronic
system checks the batteries and functions.
14
MFV52111

INSTALLATION INSTRUCTIONS

Fig A
EN
Fig B