HME HS6300 Guia De Inicio Rapido

HS6300 Headset
Drive-Thru Communication System
HEADSET OPERATION
h Power On / Off – Power (red button)
h Customer arrives: Vehicle arrival tone in headset
h Talk to Customers – A1 or A2
h Talk to Crew – B
h Volume Up / Down – Λ / V
SINGLE-LANE OPERATION
One-Touch Hands-Free (HF)
MODE SETUP: With power off, press Λ + B + Power, release buttons
Vehicle arrival tones: 1 beep
Touch-Release A1 or A2: Speak / Listen to customer
Touch-Release A1 or A2 again: Listen to customer
MODE SETUP: With power off, press B + A2 + Power, release buttons
CREW TALK
Touch-Release B: Speak and listen to crew
"B" Channel Hands Free (BHF)
Touch-release B again: Communication ends
Auto Hands-Free (AHF)
MODE SETUP: With power off, press Λ + A1 + Power, release buttons (Lane 1) or Λ + A2 + Power, release buttons (Lane 2)
Vehicle arrival tones: 1 beep
Automatic connection: Speak / Listen to customer
Car Departs: Communication ends
Push-to-Talk (PTT)
MODE SETUP: With power off, press V + B + Power, release buttons
Vehicle arrival tones: 1 beep
Press and Hold A1 or A2: Speak to a customer
Release A1 or A2: Listen to customer
MODE SETUP: With power off, press B + A2 + Power, release buttons
CREW TALK
Press and Hold B: Speak and listen to crew
"B" Channel Push-to-Talk (B-PTT)
Release B: Communication ends
CHANGE BATTERY
If you hear "Battery low" or "Change battery":
h Press battery-release button and remove battery
h Place battery in battery-charger for recharging
h Install fully charged battery in headset
HM ELECTRONICS, INC.
14110 Stowe Drive, Poway, CA 92064 USA
For HELP, call HME Technical Support at 1-800-848-4468 ● Fax: 858-552-0172 ● Website: www.hme.com ● Email: support@hme.com
Power On / Off
(Red button)
DUAL-LANE OPERATION
A1 button for Lane 1 / A2 button for Lane 2
Vehicle arrival tones: 1 beep = Lane 1 and 2 beeps = Lane 2
Touch-Release A1 or A2: Speak / Listen to customer
Touch-Release A1 or A2 again: Listen to customer
Vehicle arrival tones: 1 beep = Lane 1 and 2 beeps = Lane 2
Vehicle arrival tones: 1 beep = Lane 1 and 2 beeps = Lane 2
Press and Hold A1 or A2: Speak to customer
Release A1 or A2: Listen to customer
Battery-release latch
Battery
(blue button)
HME# 400G729
Rev A 7/14/15