KRESS FME 1101 Manual Del Usuario página 16

16 English
The rated speed of cutting tools must be at least
equal to the maximum speed marked on the pow-
er tool.
EN
Cutting discs or other cutting tools running with
overspeed can fly apart and cause injuries.
Do not use blunt or damaged router bits.
Blunt or damaged router bits cause increased fric-
tion, can become jammed and lead to imbalance.
Apply the machine to the workpiece only when
switched on.
Otherwise there is danger of kickback when the
cutting tool jams in the workpiece.
Never cut over metal objects, nails or screws.
The router bit can become damaged and lead to
increased vibrations.
Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
Take protective measures if there is danger of for-
mation of combustible or explosive dust during op-
eration that can be hazardous to health.
Example: Some dusts can be carcinogenic. Wear
a dust mask and work with a dust/chip extraction
unit, if possible to connect.
Always wait until the machine has come to a com-
plete stop before placing it down.
The tool insert can jam and lead to loss of control
over the power tool.
During operation, always ensure that the mains
and extension cable is to the rear away from the
device.
This prevents anyone from tripping over the cable
while working.
Do not carry the machine by the cable.
Move the switch to the "OFF" position before re-
moving the plug from the plug socket.
When the tool is reconnected to the mains acci-
dental starting of the machine is avoided, thus re-
ducing the risk of accidents.
Tools not in use must be locked away
safely in a dry place out of the reach
of children.
To mark the machine, do not drill into
the housing.
The protective insulation would be
bridged. Use stickers.
FME-EN / 1101
Never use the machine with a dam-
aged cable. Do not touch the dam-
aged cable and pull the mains plug
when the cable gets damaged during
operation.
Damaged cables increase the risk of
electric shock.
Residual risk. Although this information sheet
and the operating manuals for our electrical tools
contain extensive instructions on safe working
with electrical tools, every electrical tool involves
certain residual risks that cannot be completely
prevented through safety mechanisms. Therefore,
electrical tools must always be operated with the
necessary caution.
Safety rules