Tabla de contenido
Publicidad
®
Using Ellison
AllStar
with the RollModel Adapter Pad
With the use of the RollModel Adapter Pad (sold separately), the RollModel is
compatible with the complete line of Ellison AllStar Dies, as well as Sizzix Bigz
and Originals Dies.
Place the Adapter Pad on top of the RollModel Sliding Tray. Remember to place
the dies with the rubber side facing up. Then follow Steps 2-5 in Operating
Instructions.
Remember that dies must be placed rubber side up on the Sliding Tray.
Other brands of wood dies, such as AccuCut
RollModel Machine.
Use the RollModel Machine to cut a variety of different materials. See
Materials Guide on pages 11 and 12 for suggestions.
Fewer sheets of material should be used when cutting very complicated shapes.
When cutting felt, poly foam or delicate materials, place a scrap of paper over
the material to be cut.
A convenient way to store the dies is on their sides. Place the Die Storage
Rack on its side so the dies sit vertically in the rack, not horizontally. Insert
the dies alphabetically in the rack from left to right, so they are easier to find
and replace. The dies will also slide into the slot with greater ease and are
less likely to catch on the shelf divider. (Not applicable for the Wall Storage
Rack, the Work Station Rack or Carousel.)
It is important to use the Die Pick (included in the Tool Kit) to clean out the
bits of paper and other material that build up in the joints of the dies (where
the cutting rule meets). If dies are not kept clean, the scraps will
eventually push the rule slightly apart. Cleaning is especially important if
cutting thick materials such as Flexible Magnetic Sheets, Pop-Up Sponge
or Self-Adhesive Felt.
* AccuCut is a registered trademark of Tek Industries, Inc.
®
Dies and Sizzix
Helps & Hints
7
®
™
Bigz
and Originals
®*
, can be safely used in the
™
Dies
Publicidad
Tabla de contenido
