Uline H-5551 Manual De Instrucciones página 3

1
Figure 1
1
Figure 2
Figure 3
PAGE 3 OF 12
Top View
1 1 1
2 2 2 2
3
3
5
ASSEMBLY
ASSEMBLING MAIN PANELS
NOTE: Do not tighten bolts until unit is
completely assembled.
1. Place back panels (1) on a protected flat surface
so that the flanges face upward. (See Figure 1)
2. Bolt side panels (2) to back panels (1), making
sure side panels fit inside the flanges of the back
2
panels. The side panels should not go between two
back panel flanges. (See Figure 2) The ends of the
back and side panels with the two large holes are
at the bottom of the locker.
NOTE: Do not put nuts and bolts in the bottom
three holes in two outside corners. Those will
be used later to attach legs.
NOTE: Bolts will be shared between panels
that are next to each other.
3. Bolt top (3), bottom (3) and middle (3) to back
panels (1) and side panels (2). Only bolt through
middle hole when attaching to back panels.
(See Figure 3)
NOTE: Bolts will be shared between shelves
and panels that are next to each other.
4. Install one double ceiling hook (5) and two single
ceiling hooks (4) in each locker opening.
(See Figure 3)
4
0721 IH-5551