Uline DELUXE Instrucciones De Montaje página 4

DRAWER ASSEMBLY
2
# DESCRIPTION
1 Drawer
2 Drawer Housing
3 Divider
4 Plastic Tray
Keys (Not Shown)
Hardware packet (Not Shown)
NOTE: Drawer comes pre-assembled.
NOTE: The drawer and suspension have a 70 lb.
weight capacity.
NOTE: Mount drawer on opposite side of
L-Shaped Workstation.
ATTACHING TO NON-STEEL TOP
1. To free drawer (1) from housing (2), fully extend the
drawer from the housing. Flip one plastic tab on the
sliding rails up and the second plastic tab on the
sliding rails down.
2. Using housing as template, mark location of four
holes for wood screws onto underside of tabletop.
(Recommendation: 1/2" offset from front of tabletop).
3. Using 5/32" drill bit, drill holes into tabletop, drilling
about 1/2" to 3/4" deep.
4. Secure housing to underside of top, using four
14-3/4" hex head slotted wood screws.
#
5. Insert drawer into housing.
ATTACHING TO STEEL TOP
NOTE: Mounting channels are included with
the steel top. (See Figure 6) Channels may
extend past the drawer assembly.
Figure 6
1. On the underside of the table, slide mounting
channels front to back into table flanges. When
channels are aligned, mounting holes should be
approximately 14½" apart. Secure each channel
with two 1/4-20 x 5/8" bolts. (See Figure 7)
PAGE 4 OF 38
UPRIGHT AND DRAWER ASSEMBLY
4
3
1
QTY.
1
1
1
1
2
1
Mounting Channels
2. To free drawer (1) from housing (2), fully extend the
drawer from the housing. Flip one plastic tab on the
sliding rails up and the second plastic tab on the
sliding rails down.
3. Attach the drawer assembly to the mounting
channels using four 1/4-20 x 1/2" bolts. (See Figure 7)
Figure 7
4. Close the drawer.
ATTACHING MULTIPLE DRAWER UNITS
1. To free drawer (1) from housing (2), fully extend the
drawer from the housing. Flip one plastic tab on the
sliding rails up and the second plastic tab on the
sliding rails down.
2. Bolt housing together with four 1/4-20 bolts and nuts.
3. Insert drawer into housing.
UPRIGHT ASSEMBLY
1. Carefully set table upright and recheck all nuts, bolts
and screws for tightness.
2. Position upright (6) on back corner of the tabletop.
The mounting plate should be positioned directly
over the previously drilled holes. Fasten four 2⁄"
bolts and washers through uprights, tabletop and
legs using 10 mm wrench. Secure with flange nuts
on underside of table. (See Figure 8)
NOTE: Steel tops already come with drilled
holes through top.
3. Repeat with other upright. (See Figure 8)
Upright
2⁄" Bolt
Washer
Flange
Nut
Leg
Figure 8
Mounting
Plate
Upright
1021 IH-5759