Aqua Medic Titan Professional 6.000 Manual De Instrucciones página 7

1. Features
The units of the Titan Professional line are automatic machines to control and adjust the water
temperature. They work as heat pumps and switch automatically between heating and cooling to
keep the water temperature in the desired range. The main application will be for cooling down the
aquarium water. But they are also very effective heaters. The Titan 6000 Professional has a
heating capacity of 5,200 watts with only 1,400 watts of power uptake.
2. Set-up and installation
1. The cooling unit must be set up at a well-aerated place. The complete heat taken out of
the water by the unit and the waste heat of the unit itself are emitted at the unit to the
surrounding air. A build-up of heat directly at the cooling unit leads to a heavily reduced cooling
power output. Therefore, sufficient ventilation is essential.
The environmental temperature should not exceed 35° C.
2. The cooling unit has to be connected to a closed water cycle. It is recommended to place the
unit below the water surface (max. 2 m below).
3. Switch the water flow on. It is important that the water flows continuously through the cooler.
Because the temperature-sensor is placed within the unit, the heat exchanger cannot freeze in
case of a failure of water supply.
4. Before starting, the cooler should stand up straight for at least 1 hour. Connect it to 230 V
power source and switch the unit on (plug in the mains and switch on). Now, the actual water
temperature is shown on the display. Because the thermo sensor is placed in the water inlet,
always a temperature which corresponds to the temperature in the tank is shown.
3. Technical Parameters
Type
Power supply:
Cooling capacity (W):
Heating capacity (W):
Compressor power (HP):
Power uptake „cooling":
Power uptake „heating":
Rated total input current (A):
Recommended flow rate (l/h):
For aquariums up to
∆T = 5°C
∆T = 10°C
Cooling agent:
Heat exchanger:
Diameter of water inlet and
outlet:
Ambient temperature:
Temperature control range:
Max. water pressure:
Thermostat default value:
Dimensions: l x w x h (mm):
Net weight (kg):
Note:
Technical parameters are measured at an ambient temperature of 32° C and water temperature of
22° C.
Titan
Professional
6.000
220 – 240 V~
5,200
5,200
2
1.78
1.4
9.8
3,000 – 12,000 4,000 – 16,000
6,000 l
3,000 l
Temperature 20° C, difference temperature 2° C
720 x 440 x 678 735 x 460 x 727
68
Titan Titan Professional
Professional
8.000
7,200
7,200
3
2.34
1.75
12.5
8,000 l
4,000 l
R410
Titanium
1.5"
5° C - 38° C
5° C – 25° C
≤ 0.2 bar
78
15.000
380 V ~, 3 Ph.
14,900
14,900
5
3.95
2.90
20.8
8,000 – 32,000
15,000 l
7,500 l
850 x 550 x 950
150
7