E L E C T R I C A L
A)
If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your
socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13
Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs
not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-
on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved
fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a
replacement fuse cover can be obtained from your nearest electrical dealer.
The colour of the correct replacement fuse cover is that as marked on the base of the plug.
B)
If your appliance is not fitted with a plug, please follow the instructions provided below:
The wires in the mains lead are coloured in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L
or coloured red.
C O N N E C T I O N
IMPORTANT
Blue:
Brown:
( U . K .
O N L Y )
Neutral
Live