Publicidad
Idiomas disponibles
Idiomas disponibles
M - DJ SERIES
Installation
1. In order to enhance the cast function of listening to space sound, it is appropriate to set
the center part of tweeter right to the position which is higher than level of ear.
2. In order to reduce sound returning, avoid to put microphone in front ofr speaker.
3. Avoid to put the speaker, especially the uprightness speaker on the portable bookself,
dancing stage and other insteady surface, lest the speaker drop from to cause damage.
Connections
1. Please do know the matching of amplifier and speaker which you are using. (Concerned
to lowest impedance load).
2.RMS power of amplifier must be match from RMS power of speaker.
3. Connect the output jack of amplifier to one of the output jack on the speaker wire and rear
panel.
4.Make sure that the wires of amplifier and speaker are connected with correct polarity.
Reverse connection will affect the sound quality.
5. Notice that the thick and lenght of speaker wire affect to spare part and other various aspect,
it is appropriate to use the speaker of insulation double conductor.
6. Check the terminals of speaker wire to ensure the connection between the two conductor.
Elements: 1 x 10" (woofer) + Driver
Power Handling: 100 W RMS, 200 W peak
Freq. Response (-3 dB): 60 Hz - 20 kHz
Impedance: 8 Ohm
Connectors: 1 XLN4 + 1 Jack 1/4"
Insertion: 35 mm
Dimensions: 370+210 x 295 x 540 mm
Weight: 10.8 Kg
MD J SERIES
User Manual
User Manual/Manual de Uso
Pag. 1
Publicidad
