Tabla de contenido
Publicidad
Bathroom radio
OPERATE:
Before inserting batteries, double-check if the seal of the battery compartment is properly seated into
the corresponding slot and has not been moved or damaged. If the seal shows any visible damage,
the radio will no longer be fully waterproof and must not come into contact with water or any other
liquids. The dotted lines on the battery compartment cover and on the device housing must be located
side by side.
To open the battery compartment, proceed as following:
1. Make sure that the radio is turned off. To do this, the duck head must be rotated until the beak
points to OFF.
2. Use a common size no. 2 Phillips screwdriver to open the battery compartment on the bottom. It is
only necessary to loosen the screws until the cover can be removed. The screws will be retained in
the cover.
3. Insert the batteries. Be sure to match up the polarities. The polarities are indicated by the + and –
symbols on the batteries and inside the battery compartment of the radio.
4. Place the cover onto the battery compartment. Make sure that the dotted lines on the cover and on
the device housing are located side by side. Then tighten the screws.
Turning the radio on and adjusting the volume
-
Rotate the duck head clockwise to power the radio on. This will adjust the audio volume at the
same time.
-
Keep turning the head clockwise to increase the sound volume.
-
Turn the head counterclockwise to lower the volume.
Tuning into a station:
1. Turn on the bathroom radio and adjust the volume.
2. Use the band selection switch to choose the desired frequency band: Press "AM" for medium wave
and "FM" for frequency modulation stations.
3. Turn the duck's behind to select the desired broadcasting frequency.
Technical specifications:
Power supply:
3x AAA batteries, 1.5 V
Frequency range:
FM 88-108 MHz (tolerance +/-1 MHz),
AM 540-1600 MHz (tolerance +/-30 MHz)
Weight:
268 g (Without batteries)
Output power:
0.2 W
Speaker:
Broadband loudspeaker, water resistant
Safety precautions:
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
ENGLISH
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is
required. Disconnect the product from mains and other
equipment if a problem should occur. Do not expose the
product to water or moisture.
2
Publicidad
Tabla de contenido
