Pass-Through Operation; Cleaning, Care & Maintenance - Buffalo GF269 Manual De Instrucciones

Pass-through Operation

To set-up the toaster for pass-through operation:
Remove the back door of the appliance.
1.
Fix it inside the appliance by resting the curved lip of
2.
the door on the two pins at the end of the belt
[Fig. 2].
Attach the Pass-through chute to the hanging screws
3.
at the rear of the appliance.
Toasting
The BUFFALO Conveyor Toaster has 3 power levels:
'Both Elements'
Full power to both upper and lower elements
'Top Element'
Full power to upper element only
'Warm 'ECO''
Energy Saver (reduces power to minimum, providing quick heat up times when required)
The speed of the conveyor belt can also be altered to adjust the cooking level.
• Turn the knob clockwise towards LIGHT (increases the speed of the belt) for a lighter toasting.
• Turn the knob anti-clockwise towards DARK (slows the speed of the belt) for a darker toasting.
To toast:
Connect the appliance to the power supply.
1.
Set the power and belt speed.
2.
Note: BUFFALO recommend that the Conveyor Toaster is allowed to heat up for 30
minutes before use.
Place the bread on the Feeder.
3.
The bread is toasted as it travels through the appliance.
4.
If necessary, adjust the power/belt speed to achieve the desired level of toasting.
5.
Cleaning, Care & Maintenance
• Always turn Off the appliance and disconnect from the power supply before cleaning.
• Allow the appliance to cool before cleaning.
• Regularly remove and empty the crumb tray.
• Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
• Dry thoroughly after cleaning.
• A BUFFALO dealer or qualified technician should carry out repairs if required.
3
Pins
Back door
Hanging
screws
Fig. 2