Instruction Manual
DAMPFBUGELEISEN
UT-SSBRETT
Important safety instructions
When using your flatiron, basic safety precautions should
always be followed, including the following:
Read all instructions before using
1. Use iron only for its intended use.
2. To protect against a risk of electric shock, do not
immerse the iron in water or other liquids.
3. The iron should always be turned to ' Off ' before
plugging or unplugging from outlet. Never yank cord to
disconnect from outlet; instead, grasp plug and pull to
disconnect.
4. Do not allow cord to touch hot surfaces. Let iron
cool completely before putting away. Loop cord loosely
around iron when storing.
5. Always disconnect iron from electrical outlet when
filling with water or emptying and when not in use.
6. Do not operate iron with a damaged cord or if the
iron has been dropped or damaged. To avoid the risk
of electric shock, do not disassemble the iron take it
to a qualified serviceman for examination and repair.
Incorrect reassembly can cause a risk of electric shock
when the iron is used.
7. Close supervision is necessary for any appliance being
used by or near children. Do not leave iron unattended
while connected or on an ironing board.
8. Burns can occur from touching hot metal parts, hot
water, or steam. Use caution when you turn a steam iron
upside down – there may be hot water in the reservoir.
9. If the malfunction indicator goes on, the flatiron is
not operating normally. Disconnect from the power
supply and have the flatiron serviced by qualified service
personnel.
Special instructions
1. To avoid a circuit overload, do not operate another high
wattage appliance on the same circuit.
2. If an extension cord is absolutely necessary, a
10-ampere cord should be used. Cords rated for less
amperage may overheat. Care should be taken to arrange
the cord so that it cannot be pulled or tripped over.
Save these instructions
More specifically:
DO NOT let children or untrained persons use the
appliance without supervision.
NEVER immerse the iron, cable or plug in any liquid.
DO NOT leave the hot iron touching fabrics or very
inflammable surfaces.
DO NOT leave the appliance unnecessarily plugged in.
Disconnect the plug from the mains when the appliance
is not being used.
NEVER touch the appliance with wet or damp hands.
DO NOT use the power cord or the appliance in order to
pull the plug out of the socket.
DO NOT leave the appliance exposed to the weather
(rain, sun, etc. ).
DO NOT leave the iron without supervision when it is
connected to the power supply.
DO NOT fill the reservoir with water before removing the
plug from the socket.
PLEASE NOTE!
Do not use chemical additive, scented substances or
decalcifiers. Failure to comply with the above-mentioned
regulations leads to the loss of guarantee.
Description of device
(A). Soleplate
(B). Spray organ
(C). Filler door
(D). Steam dial
(E). Spray button
(F). Shot-steam button
(G). Cord bushing
(H).Plate temperature control light light
(I). Thermostat knob for temper
(J). Self-cleaning button
(K). Maximum filling level
F
D
C
B
A
K
G
H
E
I
J