Carefully remove all pieces from carton and
make sure that you have all parts listed (refer
to parts list on page 1).
If you are missing parts, please call GHP
customer service at 1-877-447-4768.
1. Insert dowels (CC) into predrilled holes in
each end of shelf rail (Q). Slip right inner panel
(J) over dowels (CC) in right end of shelf rail
(Q) until snug. Slip left inner panel (H) over
dowels (CC) in left end of shelf rail (Q) until
snug.
2. Set base (C) upright and insert 8 dowels (CC)
into pre-drilled holes in base (C). Slip inner
panel assembly over dowels in the center. Slip
lower left side panel (F) over dowels on left
side. Slip lower right side panel (G) over dowels
on right side. Make sure all panels are snug,
then secure with washers (BB) and bolts (AA)
inserted through pre-drilled holes as illustrated.
Tighten with screwdriver.
3. Attach top shelf (B) by inserting 8 dowels
(CC) into the top edge of completed assembly as
illustrated. Slip top shelf (B) over dowels (CC)
and secure from underneath with bolts (AA)
and washers (BB) through predrilled holes.
Tighten all bolts with screwdriver.
2