Removing The Battery Pack; Charging The Battery Pack - Toro PowerPlex 51138 Manual Del Usuario

Removing the Battery Pack

1. Place the chain saw on a flat surface.
2. Press down on the latch and remove the battery
pack from the cavity.
Figure 22
1. Latch

Charging the Battery Pack

Important:
Make sure to read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Plug the power cord that matches your power
outlets into the battery charger.
2. Make sure that the vents on the battery pack are
clear of any dust and debris.
3. Line up the cavity in the battery pack
with the tongue on the charger.
1. Battery pack cavity
g192109
2. Battery pack terminals
3. Battery pack venting areas
4.
5.
8).
(Figure 23)
1. Charger venting areas
2. Left indicator light
6.
7.
15
Figure 23
Make sure that the vents on the battery charger
are clear of any dust and debris.
Slide the battery pack into the charger until it is
fully seated (Figure 24).
Figure 24
To remove the battery pack, slide the battery
backward out of the charger.
Refer to the following table to interpret the LED
indicators on the battery charger.
g228487
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
g194423
3. Right indicator light