Heater Installation - Zoo Med BettaTherm BH-10E Manual De Instrucciones

FIGURE 1
Aquarium
Power Supply Cord
Drip Loop
GFCI protected outlet
DO NOT allow this heater to operate dry. Special
care should be taken to be sure that the heater
remains submerged in water when in use.
If the heater comes out of the water, unplug
immediately and allow to completely cool before
handling.

HEATER INSTALLATION:

• Note: This heater will raise the temperature
in your fish bowl or tank by approximately 5°
to 10°F (3° to 6°C) over ambient room tem-
perature. An aquarium thermometer must
be used to be sure that the temperature is
appropriate for your Betta or other aquarium
fish. In the event that the ambient room
temperature is warmer than the desired
temperature in your aquarium, be sure to
unplug the heater to prevent overheating the
water and your aquarium fish. Do not place
your bowl or tank near a window, in direct
sunlight, or any other heat source to prevent
overheating your aquarium.
CAUTION:
1.Do not plug in the heater until after complet-
ing the following steps.
2.Place the heater near the floor of the bowl or
tank as shown in Figure 2.
3.Before filling the bowl or tank with water,
add aquarium gravel or sand to the floor of
your aquarium.
FIGURE 2
BH-10
Heater
4.The heater is to be placed under a thin layer
of sand or gravel (up to 1 inch or 2,5 cm).
5.Secure the heater's power cord to the side
wall of the bowl or tank with the clip and
suction cup provided.
6.Fill the bowl or tank with dechlorinated water
to the desired level. We recommend using
Zoo Med's Betta H2O Conditioner.
7.Plug in the heater and allow the water
temperature to stabilize. This may take
several hours depending on the initial
water temperature and the ambient room
temperature.
8.Check the temperature shown on the
aquarium thermometer to be sure that the
temperature is correct for your Betta or
other aquarium fish. Bettas do best when
the temperature is between 76° and 80°F
(25° to 27°C). Temperatures required for
spawning are slightly higher at 80° to 85°F
(27° to 29°C).
If the temperature shown on your aquarium
thermometer exceeds the desired temperature
in your bowl or tank, unplug the heater to avoid
overheating your fish.
WARRANTY:
Zoo Med Laboratories, Inc. (Zoo Med) warrants
each BETTATHERM™ Mini Size Betta Bowl
Heater to be free of defects in material and
workmanship under normal use and service
for one year from the date of purchase. The
obligation under this warranty is limited to the
repair or replacement, at Zoo Med's discretion,
of the product or any part thereof, when the
product is returned to Zoo Med, freight prepaid.
No claim shall be allowed under this warranty if,
in the opinion of Zoo Med, the BETTATHERM™
Mini Size Betta Bowl Heater has been subject
to accident or improper usage, including but not
limited to: water damage, improper storage, ac-
cidental dropping, etc. This warranty is in lieu of
all other warranties and representations express
or implied. Please include your receipt, full name,
address, phone number, and email address along
with a note explaining failure when sending any
product back to Zoo Med. Please allow 4 to 6
weeks for repair or replacement. Always contact
Zoo Med Europe by phone or email, before
returning any product.
ZOO MED EUROPA
Klein Hagelkruis 13
B-2180 Ekeren Belgium
Europe: Tel: +32 475 763 663
Europe E-mail: info@zoomed.eu
www.zoomed.eu