Publicidad
Idiomas disponibles
Idiomas disponibles
4
26. Plug the kit supplied cord (1) into the block heater el
ement, route the cord up, towards the driver side. Se
cure the cord to the dip stick and existing vehicle har
ness (2) with the attached retainers.
NOTE: Be sure the cord does not interfere with the
dipstick.
27. Route the cord (1) towards the driver side, behind the TIPM, secure the cord to the existing vehicle harness with the
attached retainers.
28. Push the retaining tab into the top of the EC module bracket.
29. Seat the cord (1) using the attached clip to the inner fender.
Mar 17, 2011
K6861277
Publicidad
