Hama Neptun Manual De Instrucciones página 3

L
Hands Free Facility »Neptun«
Features and Functions
1. Volume Down button
2. Volume Up button
3. On/Off button
4. DC Socket
5. Built-in Microphone
6. LED
7. Speaker
8. Battery Door
9. Sun Visor Clip
Volume Down button
• Redial the last dialed number
• To control the volume
Volume Up button
• To control the volume
• Activate/deactivate mute mode of the microphone
If you press On/Off button, you can:
• Switch on and off
• Pair with your mobile phone
• Answer a new call
• Reject a call
• Make a new call using voice dialing
DC Socket
It serves as a recharging power socket for rechargeable batteries or supplies the power to the Car Kit when the
car charger is connected to your car.
Package contents
Accessories
1 x Car Charger
3 x AA
Rechargeable Batteries
Installation
The installation is very easy.
You must only clamp your
Handsfree Car Kit with the
Visor Clip on your sun visor.
00016402bda.indd Abs1:5-Abs1:6 00016402bda.indd Abs1:5-Abs1:6
4
Pair the Hands-free Car Kit with Your Bluetooth Mobile Phone
Put the hands-free Car Kit in pairing mode.
When the hands-free Car Kit is switched off, press and hold the "ON/OFF button" for 8 seconds. In the fi rst 4
seconds, a low tone followed by a high tone will indicate the hands-free Car Kit has turned on. At the same time,
Green LED will fl ash for a second. In the 2nd 4 seconds, a high tone will occur. Then the red and green LEDs will
fl ash alternatively, which indicates the hands-free Car Kit has entered into the pairing mode.
Notice: If you want to turn the hands-free Car Kit off, please press again the "ON/OFF button" for 3 seconds.
Put your Bluetooth mobile phone in pairing mode.
Follow the operation manual of your Bluetooth mobile phone to start the pairing process. Typically, this has
to be done by going to a setup or connect menu and then selecting the options to discover Bluetooth devices.
Bluetooth may take several seconds to establish a connection.
Your phone's display will indicate that it has found the new device "BT 77R" and asks if you want to pair it. The
mobile phone will demand a password or PIN, then you can enter a sequence of "0000".
The pairing process will then begin. The green LED will fl ash every 3 seconds indicating successful pairing.
How to Use
Answer an Incoming Call
When a call comes in, the hands-free Car Kit will ring. Press the "ON/OFF button" and you can answer the call.
The green LED will continue to fl ash once a second while the call is in session.
End a Call
While a call is in session on the hands-free Car Kit, press the "ON/OFF button and you will disconnect the call.
After the call is disconnected, the green LED will fl ash normally.
Reject a Call
When the hands-free Car Kit is ringing, press "ON/OFF button" until you hear a long beep tone.
Mute the Microphone
To mute a microphone during an active call press the "Volume Up button" for about 2 seconds and a beep tone
will indicate the microphone is muted. A periodic beep tone will be heard while the mute function is active.
To deactivate the mute mode
When the microphone is muted, press the "Volume Up button" for about 2 seconds. Then the mute function will
end and the periodic beep tone will stop.
Redial Last Dialed Number
To redial the last dialed number, press the "Volume Down" for 2 seconds. Short low tones will indicate an
attempt to redial.
Make a New Call by Using Voice Dialing
When using a Bluetooth mobile phone: Press the "ON/OFF button" on the hands-free Car Kit shortly.
Notice: Make sure that the voice dialing function is properly set up in the mobile phone and it is within the range
of the hands-free Car Kit.
Put through the call
After the beep tone on the hands-free Car Kit, you can make a voice dial by saying the name of the person on the
hands-free Car Kit. The call will be connected in a few seconds.
5
28.08.2006 12:40:21 Uhr 28.08.2006 12:40:21 Uhr