Publicidad
Enlaces rápidos
LTD 5 B
TDB 15
The Bonded Flange Center Drain Series are intended for use
Infinity Drain • 18 Secatoag Avenue, Port Washington, New York 11050
Phone 516.767.6786 • Fax 516.740.3066 • www.InfinityDrain.com
Dimension are subject to Manufacturers tolerance and change without notice. We can assume no responsibility for
Las dimensiones están sujetos a la tolerancia del fabricante y cambio sin previo aviso. No podemos asumir ninguna
with the following waterproofing methods:
° Liquid Waterproofing ° Fabric Waterproofing
Made in the U.S.A.
use of superseded or void data.
responsabilidad por el uso de datos a sustituir los nulos.
Bonded Flange
Center Drain Series
Installation Instructions
RTDB 15
TDB 20
Publicidad
Resumen de contenidos para Infinity Drain Center Drain Serie
- Página 1 ° Liquid Waterproofing ° Fabric Waterproofing Made in the U.S.A. Infinity Drain • 18 Secatoag Avenue, Port Washington, New York 11050 Phone 516.767.6786 • Fax 516.740.3066 • www.InfinityDrain.com Dimension are subject to Manufacturers tolerance and change without notice. We can assume no responsibility for use of superseded or void data.
- Página 2 Series Components: LTD 5 B Series RTDB 15 Series LT5-2 SS 5" x 5" Strainer Only with Satin Stainless Finish RT 15 B 5" Round Tile Drain Strainer LT5-2 PS 5" x 5" Strainer Only with Polished Stainless Finish BFA 42 Bonded Flange ABS Drain BFA 22 Bonded Flange ABS Drain...
-
Página 3: Instalación
(A) Strainer (B) Throat Liquid/Fabric Waterproofing (C) Bonded Flange Drain Body BFA/BFP (C1) (C2) Installation Instalación 1. Set bonded flange into a wet pre laid bed of 1. Coloque bonded flange en el húmedo mortar and allow bonded flange drain body (C) pre-establecido de mortero y permita el to recess into subfloor. - Página 4 4. When mortar layer is dry, perform 4. Cuando el mortero este seco, realice necessary waterproofing (Liquid /Fabric necesario impermeabilización (Liquida/ Waterproofing) as per local code. Ensure Tela impermeabilización) según las waterproofing layer reaches the edge of normas locales. Asegure que la capa de the hole in the drain body (C2).
- Página 5 7. Using desired floor material, mark the 7. Usando el material del suelo deseado, marque el thickness of the material along the outside espesor del material a lo largo de la parte exterior of the throat (B), so that it will finish 1/16” del el cuello (B), de modo que termine 1/16”...