Pfister Marielle 72 Serie Manual De Instrucciones página 2

Thank you for purchasing this Pfister Bar Faucet. All Pfister products are carefully engineered and factory tested to provide long trouble-free use under normal conditions.
This Bar Faucet is easy to install using basic tools and our easy to follow illustrated instructions. If you have any questions regarding your Bar Faucet installation, call
1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding.
Pfister recommends calling a professional if you are uncertain about install-
ing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually
found under the sink or near the water meter. If you are replacing an existing
faucet, remove the faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Slotted screwdriver • Pliers
• Flashlight • Cloth
Your installation may require supply lines and/or shut-off valves, cone washers,
friction rings, or other additional tools. Consult the store where your faucet was
purchased for recommended connections that may be required for you area.
FAUCET INSTALLATION STEPS
INSTALLATION:
Your faucet can be installed with or without the deck plate:
For installation using the deck plate:
Go To Step 4
For installation using the single post:
Go To Step 6
ENGLISH
• Plumber's putty
• Adjustable wrench
2
DECKPLATE INSTALLATION
4
4A
BOTTOM GROOVE
4 INSTALLING DECKPLATE
Ensure that the Plastic Putty Plate (4A) is pressed on the Deckplate (4B). Place
a bead of plumber's putty in the groove along the outer edge of the Putty Plate
(4A). Install the Deckplate (4B) over the holes in your sink.
5
5A
5 FAUCET INSTALLATION
With the spout facing forward, carefully install the Faucet Supply Hoses (5A)
through the center hole of Deckplate (5B). Make sure that the Flats (5C) on
the Faucet Body (5D) are aligned with the Flats (5E) on the Deckplate (5B).
STOP
Go To Step 8
SINGLE POST INSTALLATION
6
6 INSTALLING MOUNTING RING
Place Mounting Ring (6A) over Plastic Seal (6B) and sink hole. Align Mounting
Ring (6A) to the center of sink hole.
4B
5D
5E
5B
6A
6B
6C
5C