Electrical Interference; Inserting Batteries; Option For Connecting To Power; Turning On/Off - Pet-Corp PC7 Manual De Instrucciones

ENGLISH
2

2. ELECTRICAL INTERFERENCE

This door contains a sensitive radio receiver. Excessive levels of electrical interference can affect
the range of the system. The following guidelines will help to reduce electrical interference.
Do not install the door near other RFID microchip readers or similar low frequency devices.
• Avoid obvious sources of electrical noise such as flickering lights
• Avoid routing mains cables an DC mains adaptors close to the door

3. INSERTING BATTERIES

To insert or change the batteries remove the cartridge as per the above instructions. Then
remove the battery cover from the back of the cartridge.
Insert AA batteries. Be sure to insert the batteries the correct way around. Use the markings on
the plastic case as a reference. Check the diagram to see the battery pairs
The door can operate with two, four, or six batteries. Two batteries will give an approximate
lifetime of 9-12 months, 4 batteries will give 18-24months and 6 will give 2-3 years (based on 1
cat entering up to 15 times per day) Cold weather can affect battery life.
We recommend using good quality AA Lithium batteries to offer the best lifetime.
WARNING: Do not mix old and new batteries.
Insert batteries correctly using + and - icons for correct placement.

4. OPTION FOR CONNECTING TO POWER

To connect in simply plug it into the DC socket in the bottom of the cartridge. Be sure to place
the power pack somewhere where it won't overheat or get wet. Plug the other end into a power
outlet nearby or get a registered electrician to hardwire it in for you.Avoid routing mains cables
an DC mains adaptors close to the door.
The arrow indicates where to insert DC socket in the bottom of the cartridge

5. TURNING ON/OFF

Before turning on the door ensure the flap is closed. Turn the door on by pushing the Power
Button for 5 seconds or more (but less than 10). A flashing Green LED will indicate that the door
is on.
To turn the door off press and hold the Power Button for 5 seconds or more (but less than 10), a
Red LED will flash for 2 seconds to indicate that the door has been turned off. When the door is
turned off the flap will be unlocked. The manual locks can be used instead.
1 2
1. Power Button
2. Tag button
3. LED light indicator
3
ENGLISH
3