GE AKH18 Serie Manual Del Propietario Y Instrucciones De Instalación página 11

INSTALL THE ACCORDION PANELS
5
Slide the free end of the accordion panel
A
into the side panel rails. Slide the panel
down. Be sure to leave enough space to
slip the top and bottom of the frame into
the rails on the cabinet.
NOTE: There is a right and a left accordion
panel. Be sure to use the proper panel for
each side.
Slide the left and right accordion panels
B
into the top and bottom mounting rails.
Top mounting rail
Top left
Bottom mounting rail
PREPARE THE WINDOW
6
Cut the window sash seal to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash.
Installation Instructions
Top right
11
INSTALL THE CASE IN THE
7
WINDOW
A
Open the window and mark the center of
the window sill.
Carefully slide the case into the window
B
and center the case. Lower the window
behind the top mounting rail. Pull the
bottom of the case forward so that the
bottom mounting rail is tight against the
back of the window stool. Mount the case
to the window sill using 2 type B screws
for a wood frame or 2 type C screws with
window locking brackets for other types of
windows. Drill pilot holes, if necessary.
2 type B screws
Stool
INSTALL THE V-SUPPORTS
8
For Windows With an Outside Sill:
A Assemble the V-support and V-support
bracket with V-support nut and bolt.
Left
Sill angle
bracket
V-support
bolt and nut
B Position the V-supports
on the case bottom so
that they will be near the
outside wall. Attach a V-
support to each side of the
bottom of the case with
Type F bolts, 2 for each
support.
Type F bolt
and nut
Right
V-support