Install The Battery Pack; Remove The Battery Pack; Operation; Start The Machine - GreenWorks 4700007 Manual Del Operador

WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove the machine from the box.
4. Discard the box and package in compliance with
local regulations.
6.2

INSTALL THE BATTERY PACK

Figure 2
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
6.3

REMOVE THE BATTERY PACK

Figure 2
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
7

OPERATION

WARNING
Do not handle battery pack, switch, or machine with
wet hands. Do not expose to rain or allow liquid to
enter the motor compartment.
7.1

START THE MACHINE

Figure 3
1. Push the on/off button to turn the machine on.
NOTE
Press and hold the power booster button for max
suction power and two indicators will be on.
English
7.2

STOP THE MACHINE

1. Release the ON/OFF button.
8

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
8.1

EMPTY THE LITTER

Figure 4-7
The dust container must be emptied when it's full. Every
now and then the dust container and the filter need to
be cleaned to maintain a high suction power.
1. Push the release button to remove the dust
container.
2. Remove the filter guard together with the filter from
the dust container.
3. Turn counterclockwise the filter to seperate the filter
and filter guard.
4. Empty the dust container and filter contents into the
a waste basket.
8.2

CLEAN THE FILTER

Allow the filter to dry before you store or picking up
debris.
Often clean your filter to maintain peak vac
performance.
Clean a dry filter:
• Cleaning should be done outdoors and not in the
living quarters.
• You can use a small brush to clean the dust and
debris.
• For thorough cleaning of dry filter with fine dust (no
debris), run water through it as described under
"Cleaning A Wet Filter"
Clean a wet filter:
1. Remove the filter from the machine.
9
CAUTION
CAUTION
WARNING
NOTE
EN