Snakebyte Motion XS Instalación página 2

Installation Motion XS
Installation
Connecting the Motion XS Controller
•
Make sure to feed the wrist strap cord through the connector hook on the Motion XS Controller's cable, ensuring that the
plug can not be separated from the main controller
•
Connect the Motion XS Controller plug with the Extension Connector Port on the main controller
•
Always wear the controller's wrist strap while playing, effectively taking care that the Motion XS Controller does not get
entirely separated from the main controller
Proper use of the Motion XS Controller
The Motion XS Controller can not be used on its own, i.e. without a Wii™ Remote or snakebyte Remote XS. It adds another dimension to
the gameplay, but only complements the main controller.
When using the motion sensing features of the main controller and the Motion XS Controller please make sure not to move too
excessively. Be sure not to hurt people and/or damage objects around you. Make sure not to lose the main controller and Motion XS
Controller by only playing when wearing the wrist strap.
Consult your game's manual to find out if the Motion XS Controller is supported.
Not all games require a Motion XS Controller extension.
For further information please refer to your Wii™ console's manual.
Troubleshooting
If you encounter any problems using the snakebyte Motion XS Controller please read this section carefully before contacting our
customer support or your dealer.
1. My Motion XS Controller does not work correctly at all.
Turn off your Wii™ console and turn it on again immediately. Make sure your main controller is synced to the console and the Motion XS
Controller plug is firmly attached to the controller's Extension Port. Please refer to the installation instructions above.
2. My game seems to receive input signals although I do not even touch the Motion XS Controller.
Turn off your Wii™ console and turn it on again immediately, this time making sure the analog thumbstick of the Motion XS Controller
remains in its neutral position during startup. You may also reset the thumbstick by making sure it rests in its neutral position and
simultaneously pushing and holding A, B, Plus & Minus on the main controller it is connected with. Keep the buttons pushed for at least
three seconds.