Troubleshooting; Before Calling For Service - Sears Kenmore 580.75124 Manual Del Propietário

BEFORE CALLING FOR SERVICE
Check the following list to be sure a service call is really necessary. A quick reference to this manual may
help you avoid an unneeded service call.
THE AIR CONDITIONER WILL NOT OPERATE
Check if...
Wall plug disconnected.
House fuse blown or circuit breaker tripped.
MODE selector is OFF position.
Unit was turned off and then on too quickly.
TEMP Control set warmer than room temperature.
The Current interrupter Device is tripped.
Then...
Push plug firmly into wall outlet.
Replace fuse with time delay type or reset circuit breaker.
Turn MODE selector to the desired COOL setting.
Turn unit off and wait 3 minutes before restarting.
Turn TEMP Control clockwise to a cooler setting (higher number).
Press the RESET button located on the power cord plug.
If the RESET button will not stay engaged, discontinue use of the
air conditioner and contact a qualified service technician.
AIR FROM UNIT DOES NOT FEEL COLD ENOUGH.
Check if... Then...
MODE selector in LOW COOL position.
TEMP Control set too warm (lower number).
Room temperature below 70°F (21°C).
Temperature sensing tube touching evaporator coil,
located behind front grille.
Turn selector to HIGH COOL position
Turn TEMP Control clockwise to a cooler setting (higher number).
Cooling may not occur until room temperature rises above 70°F (21°C).
Straighten tube away from evaporator coil.
THE AIR CONDITIONER COOLING, BUT ROOM IS TOO WARM - ICE FORMING ON COOLING COIL BEHIND FRONT GRILLE.
Check if... Then...
Outdoor temperature below 70F (21°C). To defrost the coil, set selector to FAN position. Then, turn TEMP control
counterclockwise to a warmer setting (lower number).
Air filter may be dirty. Clean filter. Refer to Maintenance section of owner's manual. To defrost,
set selector to FAN position.
TEMP Control set too cold for night-time cooling. To defrostthe coil,setselectorto a FAN position.Then, setthe MODE
controlat FAN positionor "HighCool"with theTEMP controlto a warmerposition.
THE AIR CONDITIONERCOOLING, BUT ROOM IS TOO WARM.
Check if... Then...
Dirty air filter - air restricted. Clean air filter. Refer to Maintenance section of owner's manual.
TEMP Control set too warm. Turn TEMP control clockwise to a cooler setting (higher number).
Front of unit is blocked by drapes, blinds, furniture, Clear blockage infront of unit.
etc. Air distribution is restricted.
Doors, windows, registers, etc. open. Cold air escapes. Close doors, windows, registers, etc.
Unit recently turned on in hot room. Allow additional t imeto removestoredheatfromwalls,ceiling,floor,andfurniture.
THE AIR CONDITIONER TURNS ON AND OFF RAPIDLY.
Check if... Then...
i Outside temperature is extremely hot. I Set MODE on HiGH speed to bring air past cooling coils faster.
NOISE WHEN UNIT IS COOLING.
Check if... Then...
t Soundof fan hitting water- fromthe moisture removal s ystem. [ This is normal when humidity is high. Close doors, windows, and registers.
Window vibration - poor installation. / Refer to installation instructions or check with installer.
WATER DRIPPING INSIDE ROOM WHEN UNIT IS COOLING.
Check if... Then...
The air conditioner is improperly installed. Tilt air conditioner slightly to the outside to allow water drainage. Refer to
installation instructions or check with installer.
WATER DRIPPING OUTSIDE WHEN UNIT IS COOLING.
Check if... Then...
The unit is removing large quantities of moisture This is normal during excessively humid days.
from humid room.
-13-