VonHaus 3500103 Manual De Instrucciones página 5

EN
ASSEMBLY
1. Lay the Mitre Saw Stand on a flat surface.
2. Push the spring loaded pin. When the pin is fully pushed in this will allow the corresponding leg to be
lowered. Repeat this process to unlock all four of the legs.
C
3. Sit the Mitre Saw Stand upright.
4. Loosen (by turning anti-clockwise) the Locking Grips on either ends of the Mitre Saw Stand to allow enough
space to slide the 'L' Shaped Roller Bar Holders into. Tighten (by turning clockwise) once in the desired
position.
5. Attach the Rollers (E) at either end of the stand, using the Locking Grips to tighten them in place.