• Slide the upper chimney E towards the top,
locking it in with the appropriate screws in
the drill holes of the bracket Z previously
affixed to the wall (fig.9).
RECIRCULATING MODE INSTALLATION
In order to transform your cooker hood
from the exhaust version to the recirculating
version, it is necessary to install activated
carbon filters (Fig. 4).
ELECTRICAL CONNECTION
Check that the mains voltage complies with
the that required by the hood. This is indi-
cated on the plate that is applied inside the
appliance.
OPERATING CHECKS
Check lights and motor start-up on all 4
speeds.
USE INSTRUCTIONS
Version with TOUCH CONTROL on glass (ca-
pacitative)
(Fig.1)
A.
at 0 speed , and turns off the
hood (lights included)
E
B. -
speed (decreases speed and
brings the hood back to ON).
C.
+ key. Increases speed from
2° to 3° to 4° speed
D
NOTE: speed increase starts
from 1° Speed.
C
D.
ted by pressing this key, and
the motor is turned off after
15 minutes. When operation
speed is set at 4 speed , the
B
timer activates automatically
and the speed is automatically
set at 3 speed after 7 minutes.
Timer programs stop: by pres-
A
sing the "TIMER" key or incre-
asing/decreasing + OR - keys,
the timer programs are deacti-
vated.
ON/OFF: turns on the hood
Key Starts the hood at 1°
Timer – the timer is activa-
SAFETY INSTRUCTIONS
In certain circumstances electrical applian-
ces may be a danger hazard.
• The hood has been designed to remove
the kitchen smells; any other additional use
shall be regarded as non-intended.
• Aerate the room if other appliances that
are not supplied by electrical power are
being used while the hood is on.
• Do not leave the cooker on if it is not being
used.
• Do not flambé food directly under the
cooker hood to prevent the grease filter
catching fire due to flames.
• Constantly check food frying to avoid
that the overheated oil may become a fire
hazard.
• Do not check the status of the filters while
the cooker hood is operating.
• Do not touch the light bulbs after applian-
ce use.
USE AND MAINTENANCE
It is recommended to switch on the applian-
ce before cooking. It is also recommended
to leave the appliance in operation for 10
minutes after cooking is terminated in order
to completely eliminate cooking vapours
and odours. The proper function of the
cooker hood is conditioned by the regularity
of the maintenance operations, in particular,
the active carbon filter.
Clean the fan and other surfaces of the
cooker hood regularly using a cloth moiste-
ned with denatured alcohol or non abrasive
liquid detergent.
WARNING: unplug the appliance or switch
off the circuit breaker before carrying out
maintenance operations.
METAL ANTI-GREASE FILTERS (Fig.2M)
The metal anti-grease filters capture the
grease particles of the vapours that develop
during cooking, therefore they are subject
to clogging according to the frequency of
the use of the appliance.
In order to prevent fire hazard, it is recom-
mended to clean the filter every 2 months
5
E.
Light (only when the hood
is ON)