Connecting; Usage Via Touch Controls - Telestar BluTC2 Manual De Instrucciones

Connecting

Before data can be exchanged between two Bluetooth devices, these devices need to be linked to each other. This link is established
GB
through a process called pairing, where unique keys are exchanged between the 2 devices and stored for future reference and usage.
In general the devices will be automatically paired in the future if Bluetooth is enabled on both devices and they are within range of each
other. The pairing process does not need to be carried out again.
Read the manual of your audio playing device or smartphone to find out how to enable Bluetooth on this devices, how to pair devices
and use the device. The usage can be different from device to device.
– Turn the headphones on
– Press the main switch briefly. The light will blink red and blue
– Choose the headphones on the audio playing device or smartphone as soon as its name appears in the available Bluetooth
devices within range.
If the pairing process has been successful, the light in the main switch will blink blue every 2 seconds. With some audio playing devices
or smartphones a password needs to be provided to pair successfully. In this case the standard password is '0000' (4 × zero).

Usage via Touch controls

Equalizer function in Bluetooth mode
In Bluetooth mode, you can select 3 different kinds of acoustic patterns. 1. Increasing lower frequencies, 2. increasing higher frequen-
cies, 3. flat frequency range. In order to swtich between the 3 acoustic patterns, press the main switch twice.
Audio play and pause
To start playing audio, starting at the last played song, touch the Touch control surface with your finger and hold it for around 1
second. To stop playing audio or pausing the current song, touch the Touch control surface with your finger and hold it for around 1
second.
Move your finger from the top to the bottom on the Touch control surface to go to the next song.
Move your finger from bottom to top on the Touch control surface to go to the previous song.
You can also use your audio playing device or smartphone to control and use above-mentioned functions.
14
The Touch controls are located over the whole outside surface of the right ear shell.
By touching the outer surface with your finger or moving your finger in a certain direction you
can control and use different functions of the headphones.
A short delay might occur between touching the Touch control surface and the actual carrying
out of the desired command. This is normal and technically determined by the technology used.
Temporarily turn off Touch controls
You can turn the Touch controls off to prevent carrying out commands accidentally by touching
the Touch control surface.
Slide the lock slider of the Touch control to the back towards the 3.5 mini-jack audio input to
turn the Touch controls off. You can now touch the Touch control surface without the risk carry-
ing out a command unwillingly.
IMPERIAL bluTC TELESTAR