Using The Radio - Blaupunkt BWR-400 Manual Del Usuario

User manual
•The AC adaptor is used as the disconnect device and it shall remain readily operable. To be completely disconnected from
the power input, the AC adaptor shall be disconnected from the mains completely. The AC adaptor should not be
obstructed or should be easily accessed during intended use.
Battery operation
1. Remove the lid of the battery compartment by sliding it outward in the direction of the arrow.
2. Insert 4 R6/AA/UM3 batteries into the compartment. Make sure to match their polarities (+/-) to the markings inside
the compartment.
3. Put the lid back into place
Notes on batteries (not supplied)
·Do not mix different types of batteries or old batteries with new ones.
·Never recharge the batteries, apply heat to them or take them apart.
· Batteries should not be exposed to excessive heat such as sunshine, fire or the like.
·Do not throw the batteries in fire!
·Attention should be drawn to the environmental aspects of battery disposal.
·The batteries need to be replaced when: The volume decreases, or sound is distorted during operation.
·In order to avoid leakage, remove the batteries when unit will not be used for a long period of time.
·Please respect the environment. Before throwing any batteries away, consult your distributor who may be able to take
them back for specific recycling.
CAUTION:
Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type.

USING THE RADIO

1. Press the ON/OFF button to turn on the radio.
2. Use the band selector (LW/MW/SW/FM) to select band. When the band selector (LW/MW/SW/FM) is set to SW
position, use the SW selector to select among the 9 short wave bands. The corresponding band indicator is illuminated.
3. Use the Tuning control to tune to your desired radio station.
4. Adjust the volume level.
5. Press the ON/OFF button again to turn off the radio.
To enhance radio reception ability:
FM/ SW: Extend the telescopic antenna.
MW/LW: Rotate the unit horizontally for optimum reception.
CONNECTING LINE IN SOURCE
·Connect your LINE IN source (e .g. mp3 player) to the LINE IN jack on the left side of the unit, the unit will change to LINE
IN function automatically.
·To stop playback, disconnect your LINE IN source from the LINE IN jack
LISTENING WITH EARPHONES
Connect earphones (not included) to the earphone jack on unit.
Continuous use of earphones at high volume can damage the user's hearing.
SAFETY INSTRUCTION
IMPORTANT!
-
The ventilation should not be impeded by covering the openings with items such as newspapers, table-cloths,
curtains, etc.
-
No naked flame sources, such as lighted candles, should be placed on the apparatus.
-
Use the apparatus in moderate climates.
-
The apparatus should not be exposed to dripping or splashing.
-
Ensure a minimum distance of 5cm around the apparatus for sufficient ventilation.
-
Do not place objects filled with liquids, such as vases, on the apparatus.
-
The rating plate is located at back of unit.
-
Excessive sound pressure from earphones and headphones can cause hearing loss.
-
Under the influence of electrical fast transient or/and electrostatic phenomenon, the product may malfunction and
All manuals and user guides at all-guides.com
BWR-400 / BWR-401
6