AUDIOLINE Wireless Phone Jack Guia De Instalacion página 7

2) 2A: Connection of phone. Turn the switch to "S"-position for Speech (voice).
2B: Connection of dial-up modem , fax or satellite/cable set top box. Turn the
switch to "C"-position for Computer (dial-up modem, fax or satellite/cable set top box).
3) Plug the Extension unit into a power outlet and switch the power on. The light
on top of the Extension unit will after a short period glow green (if the switch
is on C) or yellow (if the switch is on S).
The Extension unit is now installed and your Wireless Phone Jack is now ready
for use.
Computer
(dial-up modem, fax or satellite/
cable set top box)
2)
Extension unit
EXT R A E X T E N SI ON U N I T S
1) Make sure the existing Wireless Phone Jack system (base and extension unit)
is powered on.
2) Unplug any cords attached to the Base unit (these will be connected again
later).
3) Plug the extra Extension unit into a power outlet near the Base unit and switch
power on. This will activate a red light on the Extension unit.
4) Plug one end of the supplied phone line cord into the Base unit and the other
end into the extra Extension unit. A red light will be activated before changing
to either green (if the switch is turned over to C = computer for dial-up modem,
fax or set top box) or yellow (if the switch is turned over to S = speech for phone).
This can take up to a minute.
5) Once the light changes on the Extension unit, unplug the phone line cord
between the Base unit and the Extension unit.
6) Replug the cords which you have unplugged.
Go to page 4 Extension unit installation to finish the installation process.
2B)
2A)
Speech
(Phone)
INS TA L L AT I O N OF
3)
7