Raider RDI-PC05 Manual Del Usuario página 13

supply.
• Press the power switch into the " ON/1" position to start your Polisher.
• Always keep the power cord out of the way of the tool's moving parts.
5. TROUBLESHOOTING
Should the machine fail to function correctly, a number of possible causes and the appropriate
solutions are given below:
1. The electromotor becomes hot
• The motor has become overloaded.
• Give the motor a chance to cool down.
• The motor is defect.
• Please contact the service address on the warranty card.
2. Machine switched on, but will not run
• Interruption in the mains connection.
• Check mains connection for fracture.
• The switch may be damaged.
• Please contact the service address on the warranty card.
6. CLEANING
Regularly clean the device's casing with a soft cloth, preferably after each use. Keep the fan
slits free of dust and dirt. Remove stubborn dirt using a soft cloth, dampened with soapy water. Do
not use solvents such as benzene, alcohol, ammonia, etc, which might damage the plastic parts.
7. LUBRICATION
The device does not need any additional lubrication.
8. Maintenance and Service.
8.1. Maintenance and Cleaning.
Before any work on the machine itself, pull the mains plug.
For safe and proper working, always keep the machine and ventilation slots clean.
In extreme conditions, always use dust extraction as far as possible. Blow out ventilation slots
frequently and install a residual current device (RCD). When working metals, conductive dust can
settle in the interior of the power tool. The total insulation of the power tool can be impaired.
8.2. Have maintenance and repair work performed only by qualified specialists. In this
manner, it can be ensured that the safety of the power tool is maintained.
The retracting blade guard must always be able to move freely and retract automatically.
Therefore, always keep the area around the retracting blade guard clean.
9. Disposal.
The machine, accessories and packaging should be sorted for environmental-friendly
recycling. The plastic components are labelled for categorized recycling. Do not dispose of
power tools into household waste! According the European Guideline 2002/96/EC for Waste
Electrical and Electronic Equipment and its implementation into national right, power tools
that are no longer usable must be collected separately and disposed of in an environmentally
correct manner.
13