Scanning And Switching Between Anynet + Devices - Samsung 4 Serie Guia Del Usuario

Scanning and Switching between Anynet + Devices

1. Press the tOOLS button. Then press the ENtER
select "Anynet+(HDMI-CEC)".
. Press the ▲ or ▼ button to select "Select Device", then press
the ENtER button.
. Press the ▲ or ▼ button to select to a particular device and
press the ENtER
device.
. If you cannot find a device you want, press the ▲ or ▼ button
to select "Setup", then press the ENtER
5. Press the ▲ or ▼ button to select "Searching Connections",
then press the ENtER
The message "Configuring Anynet+ connection..." is displayed.
When searching devices completes, the connected devices are
listed in the Anynet+ menu.
➣
Switching to the selected devices may take up to 2 minutes.
You cannot cancel the operation during the switching operation.
➣
The time required to scan for devices is determined by the
number of connected devices.
➣
When the device scan is complete, the number of found
devices is not displayed.
➣
Although the TV automatically scans devices when it is turned on using the POWER button, devices
connected when the TV is on or under a specific circumstance are not displayed in the device list.
Therefore select "Searching Connections" menu to search devices.
➣
If you have selected external input mode by pressing the SOURCE button, you cannot use the
Anynet+ function. Make sure to switch to an Anynet+ device by using the tOOLS button.
button. It is switched to the selected
button.
English - 
button to
tV
button.
Anynet+ (hDMI-CEC)
Auto turn Off
Searching Connections
P9
View tV
Select Device

Record

Menu on Device

Device Operation

Receiver :Off

Setup

Move Enter
Move Enter Return
Return
Setup
: On
: Yes
Move Enter



Return