AEG AquaSense Manual De Instrucciones página 10

Filter through 2 litres of water
8
• Before using the AquaSense™ jug you need to activate the
PUREADVANTAGE™ filter in the following way
o Place the jug under the tap and filter 2 litres of water .
o Discard the filtered water before start using the jug .
2. Filling the AquaSense™ Jug
• Place the jug under the tap with the opening positioned directly under
the tap water outlet .
• Hold the jug under the tap and turn the water on . The pressure of the tap
water will open the pour through filling lid and start filling the hopper .
3. AquaSense™ Capacity
• Large Jug: 1 .6 liters filtered water capacity
(2 .3 liters total capacity)
• Small Jug: 1 .2 liters filtered water capacity
(1 .6 liters total capacity)
4. Lifetime for the PUREADVANTAGE™ filter
• The PUREADVANTAGE™ filter achieves a filter capacity of approximately
150 liter of tap water .
• We recommend changing the PUREADVANTAGE™ filter after 30 days to
keep optimized performance .
• To change the filter; pull the ring on the PUREADVANTAGE™ filter .
5. Store the PUREADVANTAGE™ filter
Store the sealed PUREADVANTAGE™ filter in a cold and dry place in no direct
sun light sealed in the plastic packaging to keep the optimized performance
of your filter .
6. Care of AquaSense™ and the PUREADVANTAGE™ filter
• Discard the water if it's not is used for two days .
• We recommend to store your water filter in a cool place and remember
that water is a foodstuff . Please consume filtered water within one to two
days .
• The AquaSense™ Jug (excluding the Life Time Indicator) is dish washer
safe .
• Before cleaning your AquaSense™ Jug in the dish washer, take out the Life
Time Indicator .
7. Life Time Indicator
The Life Time Indicator reminds you when it is time to change the
PUREADVANTAGE™ filter . Each dot refers to a lifetime of about one week .
The recommended PUREADVANTAGE™ filter lifetime of four weeks (30 days)
equals four dots (100%) . After each week one circle will disappear to show the
remaining filter life time .
This is how the Life Time Indicator works:
1 . Push the STATUS button to activate the display .
2 . To see the status of the PUREADVANTAGE™ filter anytime; press the
button 0 .5-2 seconds . For example; when four lights are visible the
filter is 100% full with four weeks of usage left .
3 . To reset the timing press the button 3 seconds or more .
4 . Change the PUREADVANTAGE™ filter when all the lights are blinking .