Cleaning And Storage - Kaz DT-700 Serie Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
• Align the neck of the fan with the Fan Head (Fig. 1).
• Carefully snap the Fan Head into the Neck/Base by
firmly pushing the motor housing down until it
securely locks into the Neck/Base (Fig. 2).
NOTE: The Fan Head and Neck/Base only snap
together one way. The indentation on the Neck area
should be lined up with the power cord extrusion at
the rear of the Fan Head.
Once assembled this fan will not disassemble.
OPERATION
• Be sure your fan is in the OFF position (O).
• Place your fan on a level and dry surface.
• Plug the power cord into a polarized 120 Volt AC
wall outlet.
• Tilt fan to the desired angle by firmly grasping the
handle with one hand while holding the base with the
other hand. Rotate and tilt the fan head to aim the
airflow as desired (Fig 3).
• To operate, turn the Speed Control Knob to the desired
position: HIGH (III), MEDIUM (II), LOW (I) (Fig. 4).

CLEANING AND STORAGE

Turn off and unplug the fan before cleaning.
• Use only a soft, damp cloth to gently wipe and clean the external areas of
the fan.
• DO NOT immerse the fan in water and never allow water to drip into the
motor housing.
• DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
REMOVAL OF THE FRONT GRILLE FOR CLEANING:
DO NOT remove the fan grille unless the power knob is in the
Off position (O) and the power cord is unplugged.
DO NOT RUN THE FAN IF THE GRILLE HAS BEEN REMOVED.
• Remove the Front Grille by unscrewing the 4 screws located on the back of
the fan head (Fig. 5).
• Unscrew the screws using a standard phillips head screw driver (Fig. 6).
NOTE: The screws will remain attached to the rear housing to ensure they are
not lost. Do not try to remove the screws from the housing.
2
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Fig. 5
Fig. 6