MESTIC RTA-2500 Manual página 27

INTRODUCTION FOR SPECIAL FUNCTION
About AUTO RUN
When AUTO RUN mode is selected, the setting temperature will not be displayed on the LCD, the unit will be in ac-
cordance with the room temp. automatically to select the suitable running method and to make ambient comfortable.
About turbo function
If start this function, the unit will run at super-high fan speed to cool or heat quickly so that the ambient temp. ap-
proachs the preset temp. as soon as possible.
About Blow over heat
(This function is applicable to partial of models)
When the unit is running in Heat mode or Auto Heat mode, compressor and indoor fan is running, to turn the unit off,
the compressor, outdoor fan will stop running. The upper and lower guide board rotate to horizontal position, then the
indoor fan will run at low fan speed, 10s later, the unit will turn off.
WIFI Function
Press "MODE" and "TURBO" button simultaneously to turn on or turn off WIFI function. When WIFI function is turned
on, the "WIFI" icon will be displayed on remote controller; Long press "MODE" and "TURBO" buttons simultaneously
for 10s, remote controller will send WIFI reset code and then the WIFI function will be turned on. WIFI function is de-
faulted ON after energization of the remote controller. (This function only applicable for some models. )
16
OPERATION GUIDE
General operation
1. After powered on, press ON/OFF button, the unit wi start to run. (Note: when it is powered on, the guide louver
of main unit will close automatically.)
2. Press MODE button, select desired running mod
3. Pressing + or - button,to set the desired temperatur (It isunnecessary to set the temp. at AUTO mode.)
4. Pressing FAN button, set fan speed, can sele LOW, MID and HIGH.
5. Pressing button, to select the swin
Optional operation
1. Press SLEEP button, to set slee
2. Press TIMER ON and TIMER OFF button, can set the scheduled timer on or timer off.
3. Press LIGHT button, to control the on and off of t displaying part of the unit (This function may be not available
for some units).
4. Press TURBO button, can realize the ON and O of TURBO function.
5. Press LED button,can turn on or turn off the light the panel.
17