Prilux Imagine Guia De Inicio Rapido página 3

Imagine
LED DIMMER
3/4
PROPERTIES
• 1x5A
• 5~24V DC
• IP40
• Cable length: 120mm
• Working Temperature -30~60º
• Range 15m (Open field)
FUNCTIONS
1. Turn ON / OFF
• Press this key to switch on or off the controller. Press and hold this key will
force to switch off the controller. The controller will memorize the on/off
status and restore the on/off status and brightnees level on each power
on moment.
2. Increase Brightness
• Press this key to increase the output led brightness. Preaa and hold this key
will continously increase the brightness.
3. Decrease Brightness
• Press this ket to decrease the output LED brightness. Press and hold this key
will continously increase the brightness. When controller is off, hold press
this key turn on the controller and jump to minimum brightness.
4. Remote controller indicator.
• This indicator will blink when remote controller works.
5. Power supply
• The controller unit can work from DC 5V to 24V. The red power cable should
be connected to power positive and black to negative. Please make sure
the power is capable for the load wattage.
6. LED Output
• The controller unit supports constant voltage driving LED products. Teh red
cable should be connected to LED positive and black cable to negative.
The red cable is internal connected to power supply positive in controller
unit.
• The controller unit has output overload protection function, please check
whether the output is short circuit or over loaded if the controller stop
working.
• CAUTION! Do not short circuit or overload the LED outputs. this may lead to
permanent damage!.
OPERATION
7. Using Remote
• Please pull out the battery insulating tape befare using. The remote
controller use CR2032 cell battery, it can last for 2 years for regular usage.
For proper receiving re mote signa 1, please do not install the controller in
closed metal parts.
8. Pairing new remote
• The remete and main unit is 1 to 1 paired as default. Furthermore, one
main unit can be paired to 5 remate controllersand every remete can be
paired to any main unit.Please do following steps to pair a new remote:
1. Plug off the power of main unit and plug in again after more than 5
seconds.
2. Press remate 'on/off' and 'decreasing brightness' key together in 5 se-
conds after main unit powered on. After this operation, the controller's
indicator will flash white for 3 times to display the new remete is ac-
cepted. The latest paired 5 remete controllers can be recognized.
9. Optional Wall Switch Remote
• The controller can also work with the optional wall switch type re mote
controller RM07. This remate controller has the same function and usage
as the default hand hold remete controller. lt can be sticked on the wall
for fixed place operation.