Publicidad
Idiomas disponibles
Idiomas disponibles
Step 8
Secure the lower and upper latches
with the mounting screws provided.
Step 9
upper and lower spindles of the gate frame on the upper and lower hinge pins. Secure the
spindles in place by tightening the set screws with the Allen wrench. Then slide the top
portion of the hinge back on the hinge pins until it clicks securely in place. (9a ~ 9c)
9a
9a
Step 10
Loosen the set screws with the Allen wrench, pull the latch spindles out. The upper and
lower latch spindles must be engaged. Swing the gate closed to verify that the latch
spindles secure into the upper and lower latches. Secure the spindles by tightening the set
screws with the Allen wrench. (10a ~ 10c)
Note:
Do not pull spindles out over the red line.
10a
10d
Distance A
A
Min:1.07"(27.1mm)
Max:2.44"(62.05mm)
9b
9b
10b
Place the gate in the opening
so that the distance A is
Min. 1.07" (27.1mm) and
Max. 2.44" (62.05mm).
A
8
9c
9c
10c
Page 5
9d
Note:
Do not pull
spindles out exceeding
the red line. (9d)
9d
Publicidad
