Thermador VCIN Guia De Inicio Rapido

Before you begin, read these instructions carefully. It is
recommended that the Remote Control be wired to the
hood after the hood is installed.
NOTE:
When using the Custom Insert with remote the unit loses
the "AUTO" function and the over-temperature heat sensor
described in the Use & Care Guide.
1. Access wiring
a) Remove filters, spacers and grease trays.
b) Remove the junction box cover (refer to Figure 5
on page 2).
c) Remove three screws holding stainless steel panel
to canopy.
Figure 1: Remove stainless steel panel
d) Remove core partition (Figure 2).
Figure 2: Remove core partition
VCIN or VCIB Remote Control
Installation Instructions
2. Connecting the harness to the relay board
a) Insert remote harness end into the mounting hole,
as indicated in Figure 3, until it clicks.
Remote
Harness
b) Run harness through core partition hole (Figure 4).
c) Unplug harness from the remote control to the
relay board (Figure 5).
Harness
Mounting
Hole
Figure 3: Remote Harness Mounting Hole
Figure 4: Wire Routing through Partition
English 1