Attaching The Device - Dometic MK 140 Instrucciones De Montaje

Attaching the device

5 Attaching the device
When selecting the installation location, observe the following instructions:
 The device must be installed vertically on a wall.
 The device must be installed in a place that is protected from moisture.
 The device may not be installed in areas with easily flammable materials
(e.g. gas cylinder lockers).
 Do not install the device in a dusty environment.
 The place of installation must be well ventilated. A ventilation system must
be available for installations in small, enclosed spaces. The clearance
around the device must be at least 25 cm.
 There must be free space in front of the ventilation grills.
 When ambient temperatures are higher than 40 °C (such as in engine or
heating compartments, or when exposed to direct sunlight), the heat pro-
duced by the device when under load can lead to automatic shutdown.
 The device must be installed on a level and sufficiently sturdy surface.
A
NOTICE!
Before drilling any holes, make sure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
Attach the device as follows:
➤ Screw one screw through each of the four bore holes in the four fastening
tabs (fig. 1 7, page 3).
8
MK140
EN