Publicidad
CONNECTIONS
Before using your monitors please remember to
ensure that all the cables are firmly connected.
When powering on, turn your mixer/output
equipment on first, followed by your monitors.
When powering down, turn your monitors off first,
followed by your mixer/output equipment.
Follow the below process when powering on
your monitors:
1. Lower your mixer/output equipment master
outputs to the lowest setting.
2. Connect the mixer/output equipment left output
to the left-side monitor input, and the mixer/
outboard equipment right output to the right-
side monitor.
3. Set the monitor volume to approximately the 12
o'clock position.
4. Run an audio signal (e.g. music) through your
mixer/output equipment and raise the output
level on your mixer/output equipment to a
comfortable listening level.
7
Publicidad
