Cleaning And Maintenance - Concept CA1000 Manual Del Usuario

EN
EN
3. TIMER BUTTON:
1. By pressing this button, you can set the air purifier operation time to 2, 4 or 8 hours (2H, 4H, 8H). The appliance turns
off automatically after the set time.
2. Press the timer button and select the desired length of operation. The indicator shows which option is selected.
3. If you want to select continuous operation, press the timer button repeatedly until the indicator (2H, 4H, 8H) turns
off.
Note: Disconnect the appliance from the mains when you are not going to use the appliance.
FILTER INSTALLATION AND REPLACEMENT
FILTER REPLACEMENT INDICATOR
If the POWER indicator is flashing, the filter needs to be changed. Replace the filter as instructed, then press and hold
the on/off button for 5 seconds and restart the system. The indicator will stop flashing. The combined filter lasts about
6 months.
A label for writing down the date of filter replacement.
ENTER THE DATE OF INSTALLING THE NEW FILTER
Day Month
Place the label inside the appliance.
1. Open the front cover of the appliance.
2. Grab the combined filter by the two straps and remove the filter.
3. Insert a new combined filter into the appliance. Make sure you have placed the filters correctly.
4. Attach the pre-filter to the combined filter.
5. Close the front cover and secure it properly.
6. Press and hold the on/off button for 5 seconds to reset the indicator.
36
48
Year

CLEANING AND MAINTENANCE

Clean the air purifier at least once a month, as well as the pre-filter, carbon filter and HEPA filter. You may need to
increase the frequency of cleaning demanding on the surrounding environment.
COMBINED FILTER
Clean the filters using a vacuum cleaner with a brush attachment attached. This removes the fibres and other dirt.
Front side (pre-filter and carbon filter)
NOTE:
• Only a pre-filter is washable. Make sure the pre-filter is dry prior to placing it in front of the combined filter.
• The combined filter works as a single filter system and it includes the following: pre-filter, carbon filter and HEPA
filter.
UV LAMP REPLACEMENT
1. Use a screwdriver to open the UV lamp cover.
2. Carefully release the UV lamp from the holder and disconnect from the connector.
3. Attach a new UV lamp to the connector and then secure it back into the holder.
Do not touch the glass part of the UV lamp, it may damage the lamp.
Note: Do not look directly into the UV lamp when it is on.
NOTICE
Wipe the outside of the appliance with a dry, soft, clean cloth.
NOTE: Do not insert fingers or any foreign objects inside the appliance.
WARNING Do NOT use gasoline, thinner, harsh detergents, etc. to clean the exterior or interior parts. You could damage
the appliance.
Never use alcohol or other solvents.
CA1000 CA1000 CA1000
CA1000 CA1000
EN
EN
Rear side (HEPA filter)
37
49