Black and Decker P2211 Manual Del Usuario página 4

ENGLISH
Do not use the appliance if any part

is damaged or defective.
Have any damaged or defective

parts repaired or replaced by an
authorised repair agent.
Before use, check the power supply

cord for signs of damage, ageing and
wear.
Do not use the appliance if the power

supply cord or mains plug is
damaged or defective.
If the power supply cord or mains

plug is damaged or defective it must
be repaired by an authorised repair
agent in order to avoid a hazard. Do
not cut the power supply cord and do
not attempt to repair it yourself.
Never attempt to remove or replace

any parts other than those specified
in this manual.
Warning symbols
The following symbols are used in this
manual:
Do not use this appliance near
bathtubs, showers, basins or
other vessels containing water.
When the hairdryer is used in
a bathroom, unplug it after
use since the proximity of
water presents a hazard even
when the hair dryer is
switched off.
Denotes risk of personal
!
injury or damage to the
product in case of non-
observance of the instructions
in this manual.
Denotes risk of electric shock.
Electrical safety
This tool is double insulated in
accordance with EN 60335;
therefore no earth wire is
required. Always check that
the power supply
corresponds to the voltage on
the rating plate.
4
To avoid the risk of electric
shock, do not immerse the
cord, plug or motor unit in
water or other liquid.
For additional protection, the installation
of a Residual Current Device (RCD)
having a rated residual operating current
not exceeding 30mA is advisable in the
electrical circuit supplying the bathroom.
Ask your installer for advice.
Labels on tool
The following pictograms are shown on
the appliance:
Cool shot:
To help style the hair
2 speeds:
Speed 1, low speed
Speed 2, high speed
3 heat settings:
Position 1, warm air
Position 2, hot air
Position 3, very hot air
Features
1. Cool shot button
2. Ion indicator
3. Heat control switch
4. Speed control switch
5. Hanging loop
6. Concentrator nozzle
7. Diffuser nozzle
8. Rear cover
Assembly
Warning! Make sure that the appliance is
switched off and unplugged.
Fitting and removing the attachments
(fig. A)
Allow the appliance to cool before

changing the attachments.
Fit the diffuser nozzle (7) or the

concentrator nozzle (6) by pushing it
onto the outlet sleeve until it snaps
into place. Removed the item by
pulling it from the appliance.