Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 13
STEP 13
1. Attach top board (1) to pre-assembled cabinet by inserting cam bolts into cam lock holes,
wood dowels into dowel holes and pin into holes on rear support board (4), center
support panel (5), right side panel (6) and door (7).
2. Insert 6 cam locks (B) into cam lock holes on rear support board (4), center support panel
(5) and right side panel (6) and rotate clockwise to secure cam bolts.
STEP 14
STEP 14
1. Insert 4 plastic holders (F) into holes on positions that you desire for the shelf and put
shelf (8) onto 4 holders (F).
2. Place drawing with hole positions on wall you desire to fix cabinet and drill 2 holes
through hole positions on drawing.
3. Insert 2 plastic anchors (Q) into holes on wall and attach cabinet in place by inserting 2
anchor screws (P) through holes on back top cross bar (11) and tighten cabinet to wall.
Publicidad
