Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To install the batteries, the following tools are required:
Precision screwdriver
M8 & M10 Torque wrench
Safety gear for personal protection
Insulated gloves
Make sure that the inverter AC and DC connections are turned off before connecting the power cable to the battery bank.
Make sure that the power switch of the inverter and the battery are turned off before connecting the power cable to the battery.
NOTE
USE PROPER BRACKETS, SUPPORTS AND/OR STRAPS TO HANDLE THE WEIGHT OF THE BATTERY. A WELL
VENTILATED, HEAVY DUTY BATTERY CABINET IS RECOMMENDED
t is suggested that the batteries are kept as close as possible to the inverter or DC load. The following is a suggested wiring option for 1meter
DC cable. Please find the following minimum wire size, in case of having DC cables longer than 1m, please increase the cross section of the
cable to reduce the losses.
No.
1
2
Performance of any product can be improved by thicker and shorter cables, so if in doubt, round up and keep the length as short as possible.
The torque rating range for the DC terminals is 9NM-12NM, and the suggested torque is
9NM. Over torqueing may cause the bolt to break
19
MANUAL DE USUARIO BATERÍA SAUCO / BATTERY SAUCO USER MANUAL
Inclinometer
Drill
Safety goggles
Model
DC output voltage
ILFP-3072
25,6Vdc
ILFP-3840
25,6Vdc
Table 5. DC wiring for Sauco batteries
NOTE
This product is heavy and challenging to lift. Lift handles are recommended.
Wire gage
AWG #2
AWG #2
Pencil or Marker
Safety boots
www.intipv.com
Publicidad
Tabla de contenido
