Explanation Of Symbols; Operating Mode - Desoutter SSCMBN Manual De Instrucciones

6159922540_02
Original instructions.
© Copyright 2016, Ets Georges Renault
44818 St Herblain, FR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
This product is intended to be used with the
Desoutter SLBN003 to SLBN120 tools.
No other use permitted.
For professional use only.
EMC restriction of use: for industrial use only.

EXPLANATION OF SYMBOLS

Information.
TECHNICAL DATA
● See page 3.
DESCRIPTION
● See page 3.
1 Green Led
2 Increase button
3 Decrease button
4 Slow start switch
5 Display
6 Cable (to controller)
7 Connector (to screwdriver)

OPERATING MODE

● Switch off the power controller.
● Connect the cable (6) to controller and plug
the screwdriver on the connector (7).
● Turn on the power controller.
● Adjust the speed and time using ▲ and ▼
buttons.
● Press both ▲ and ▼ buttons during 2 sec. to
enter in settings mode. The display (5) shows
[RC].
● Press both ▲ and ▼ buttons during 1 sec. to
change or to set next function. The display (5)
shows [RC] - [SP] - ...
● Screwdriver control will be disabled and the
power light will flash each 5 sec. between
setting mode.
● Use ▲ or ▼ button to change the setting
value:
- RC : Slow start time 0.0 ~ 9.9 sec.
- SP : Slow start speed level L0 ~ L9.
● Toggle the slow start switch to disable or
enable [RC] [SP] function. The display (5) will
turn off when function is disabled.
Press▲ button for 6 sec. to reset to
factory default values (RC:0.0, SP:L0).
When disconnect or loss communication
with screwdriver, the LED (1) blink every
0.5 sec.
4 / 8
English
11/2016