Logitech ViewPort AV 100 Manual De Instalación página 10

623631-0403_Elkhorn-US.book Page 7 Tuesday, September 7, 2004 5:19 PM
Camera Pause Button
Pressing the camera Pause button closes the camera's privacy shutter. The Video Streaming Status and
Pause/Mute LEDs on the camera flash. Both video and audio are paused. Pressing the Pause button
again opens the privacy shutter, and both the Video and Pause LEDs stop flashing. Video and audio are
now on. Note that some applications may allow audio to be muted while video is on, or pausing video
while audio is on.
Headset Standby Mode
When not using the headset, place it in standby mode to conserve battery power. Once the headset
has been turned on, you can switch between standby mode and active call mode by pressing
and releasing the headset Multi-function button. When the headset is in standby mode, the Camera
Bluetooth Link LED blinks slowly and the Headset LED flashes three times. When the headset is in active
call mode, the camera Bluetooth Link LED turns solid blue and the Headset LED flashes four times.
Adjusting the Microphone Boom
The microphone boom should be stored in its "closed" position with
microphone element resting just above the Multi-function button.
To adjust, swivel the boom gently and stop where the microphone
element is as close to your mouth as possible.
IMPORTANT: DO NOT FORCE THE MICROPHONE BOOM. IF YOU FEEL
IT STOP, DO NOT FORCE IT. FORCING THE BOOM PAST THE HARD STOP
IN EITHER DIRECTION WILL DAMAGE YOUR HEADSET.
Lighting
For the best video experience, use a bright light source behind the camera.
7
English