Manuales relacionados para Mooreco 689D3
Resumen de contenidos para Mooreco 689D3
- Página 1 Mobile Floor Display Panels ASSEMBLY INSTRUCTIONS INSTRUCCIONES DE ENSEMBLAJE INSTRUCTIONS DE MONTAGE DO NOT THROW AWAY! NO LA TIRE NE PAS JETER UPDATED AS OF: 05/06/2021 1 of 5...
-
Página 2: Parts List
Parts List Hardware P1 - Board A - M6 x 40mm Screw P2 - Upright B - M6 x 15mm Screw P3 - Crossbar C - Plastic Endcap P4 - Foot D - Locking Casters E - Non-Locking Casters F - Ganger (0,90,120) G - Washer H - Lock Nut I - Allen Wrench... -
Página 3: Avertissements
WARNINGS AND DISCLAIMERS ADVERTENCIAS Y RENUNCIAS AVERTISSEMENTS Review full assembly instructions and Previo a comenzar el proceso de Avant de commencer l’ assamblage check that all parts are present before ensamblaje favor revisar veuillez consulter instructions beginning assembly. Heavy or large instrucciones y asegurarse que cuenta con complètes et vérifier si vous avez toutes furniture may require multiple persons in... - Página 4 With Board, Uprights, and Crossbars laid out on a protective surface, slide pieces STEP 1 onto edges of Board until flush. Make sure side holes on Uprights are aligned with threaded inserts on either end of Crossbars. Side Holes With Crossbars and Uprights in position, secure in place with screws (A) and washers STEP 2 (C) inserted through side holes in Uprights.
- Página 5 Use Gangers with screws (A) and Lock Nuts (D) to connect display panels together in STEP 3 desired configuration. For radial configuration (see front page) use a total of six of the 120 degree style gangers. If setting up individual mobile floor panels slide Foot with Casters over bottom of Single Option Upright and secure with screw (B).